VS4-10 Phoenix vp rc car 3d print op DIG/Battery OD Servo Bracket Kit

DIG/Battery, OD Servo Stand Kit

[Product introduction]
Body weight reduction is crucial to the performance of the model climbing car. This product will replace the VS4-10 Phoenix
The original car's standard steering gear (weighing about 60 - 80 grams) was replaced with a POWER HD TR4 steering gear
(Weight about 14 grams); at the same time, a steering gear protection mechanism is added to protect the steering gear (to prevent stalling and burning)
At the same time, it also effectively reduces the impact on the gearbox (gearbox) when shifting.
This kit is a non-destructive installation without damaging any structure of the original vehicle.
Carbon fiber battery holder can be installed with up to 100mm standard 2S short lithium battery (shorty)
Or a smaller battery, which can further reduce the weight of the car body.

[Materials and craftsmanship]
- 3D printing manufacturing, nylon material;
- Good impact resistance, high temperature resistance of 175 ° C, not easy to deform, light weight.
- Thickness 2mm.

[Installation Instructions]
Install according to the original car position, and instructions cannot be provided.

[Note] This product does not contain POWER HD TR4 servo.

DIG/Battery Holder Kit